![]() front bash bar is designed to be strong enough to take a beating while being forgiving enough to protect your chassis from significant damage in most situations. Or if you have a Kouki front end on your Zenki, then you'll need the Kouki bar. Made from 1-1/2 DOM steel tubing, the Detroit Drifting Co. ![]() 2x mount up bolts are included for the front bar & 4x mount up bolts for the rear bar.along with a pair of fancy-shmancy end caps - you can add the bicycle tassles yourself. Be sure to specify if it's for a Trueno or Levin. And if you have an S15 front end on your S14, then you'll need an S15 bar. 125' wall mild steel tube - these are made to order: please expect a lead time of at least 2 weeks from the date of your order. So if you have an S14 front end on your S13, then you'll need the S14 bar. For any S-Chassis bar, the bar would depend on the BUMPER that you are using, not the chassis.The length of our jack points are designed based off of the OEM bumper height to keep it level, without protruding past the OEM bumper.The "Upper Support" option is only available for 180sx (pop-up).The "Corner Bracing" option is only available for S-Chassis platform.S30 bars are not guaranteed to fit perfectly due to chassis inconsistencies.R32/R33 rear bumper requires moderate trimming to clear the jack point.R32: If you have N1 vents, then you may need to trim the vents to clear our bash bars.Miata: We haven't test fit our NA rear bars on any NB's so we are unable to confirm if they are interchangeable or not.IS300 - Will work with JDM Altezza bumper.Genesis chassis' mounting points are too weak to support a jack point, so we only offer a basic version.FRS front bash bars only fit on the 2012-2016 models.280z bars are not guaranteed to fit perfectly due to chassis inconsistencies.AE86 bars come with universal bumper tabs that are not guaranteed to fit any specific bumpers.(Heat from welding the jack point causes the support arms to pull inward.) We recommend using a pry bar to assist with installation and a small amount of force to get the support arm to slide into the OEM mount. ![]() Bars with jack point: It is normal for our bash bars with jack points to be a tight fit upon installation.Using incorrect hardware may lead to damaging product. OEM hardware is required for the install.Bash bars have not been tested on every bumper, so some modification or trimming may be required. Our bash bars are not guaranteed to fit cars that have previously been in an accident.Or if you have a Kouki front end on your Zenki, then you'll need the Kouki bar. And if you have an S15 front end on your S14, then you'll need an S15 bar. But what usually will end up in a bash or batch file, can be also done in. OEM hardware is required for the install. game is that the turns will keep increasing as you press the space bar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |